SMD-340/SMD-349 (3.5", 1.44MB)

THE JUMPER BLOCK IS LOCATED ON THE REAR OF THE DRIVE BETWEEN THE
POWER CONNECTOR AND THE DATA CONNECTOR.
 ____________________________________________________________________
|                                                                    |
|                                                                    |
|  |---------|   -------------------------      -------------------  |
|  | o o o o |   | 9|10|11|12|13|14|15|16|     | ooooooooooooooooo | |
|  |---------|   | 1| 2| 3| 4| 5| 6| 7| 8|     | oxooooooooooooooo | |
|                -------------------------      -------------------  |
|____________________________________________________________________|
        ^                    ^                            ^
        |                    |                            |
     (POWER               (JUMPER                       (DATA
    CONNECTOR)             BLOCK)                     CONNECTOR)

DRIVE SELECT

------------------------------------------------------------------
JUMPER BETWEEN 14 & 15 | DRIVE SELECTED BY DS0
JUMPER BETWEEN 15 & 16 | DRIVE SELECTED BY DS1 (DEFAULT)
JUMPER BETWEEN  6 & 7  | DRIVE SELECTED BY DS2
JUMPER BETWEEN  7 & 8  | DRIVE SELECTED BY DS3
------------------------------------------------------------------

MODE CONTROL
------------------------------------------------------------------
JUMPER BETWEEN 4 & 5  | MODE IS SWITCHED BY INTERNAL SENSOR (DEFAULT)
JUMPER BETWEEN 5 & 13 | MODE IS SWITCHED BY HDI INPUT
------------------------------------------------------------------

HDI LOGIC (ONLY USED IF 5 & 13 ARE JUMPERED TOGETHER)
------------------------------------------------------------------
JUMPER BETWEEN 1 & 2  | 2M MODE IS SET BY HDI = HIGH
JUMPER BETWEEN 2 & 3  | 2M MODE IS SET BY HDI = LOW (DEFAULT)
------------------------------------------------------------------

NOTE: PINS 9,10,11,& 12 ARE USED FOR TESTING PURPOSES
      - DO NOT JUMPER THESE PINS